ELECRAFT KBPF3 Specifiche

ELECRAFT® K3 HIGH-PERFORMANCE 160 – 6 METER TRANSCEIVER KBPF3 GENERAL COVERAGE RECEIVE OPTION INSTALLATION INSTRUCTIONS Rev C, December 22, 20

10Installing the KBPF3 Board There are three connectors on the bottom of the KBPF3 board that must be properly mated to P44A, P44C and P44E on the

11Replacing the Top Cover REPLACE ALL THE SCREWS! The K3's chassis has excellent rigidity despite its light weight. The screws that hold the

2Contents Introduction...

3Introduction This manual covers the installation of the KBPF3 General Coverage Receive option in your K3 transceiver. The KBPF3 provides the prop

4 Elecraft 1-Year Limited Warranty This warranty is effective as of the date of first consumer purchase. It covers both our kits and fully assemb

5Inexpensive static dissipating work mats are readily-available that will steadily and safely drain off any charges built up on parts or circuit bo

6Parts Included The following parts should be included in your kit. Check to ensure you have them all. If any parts are damaged or missing, contact

7Installation Procedure As you install components and reassemble your K3, be sure all the screws are in place and secure, but do not over tighten

8Installing the Standoffs Check the RF board that covers the bottom of the chassis area to see if the standoffs shown in Figure 2 are installed. (N

9Install two standoffs on the RF board as shown Figure 4. Be sure you place a split lock washer under the head of the screw and between the standof